WANTED - 6 POINT BOLT IN CAGE

[JAMIE-TYPERV6]

Hi all,

I've been searching high and low for a 2nd hand roll cage for the project car... but no luck as of yet so thougt it might be worth a shot here.

I'm after a 'bolt in' type '6 point' cage (pic below)... as I'll be modding it myself with extra bracing. It needs to be the 'through dash' type... and most importantly for a 2 door with the straight rear bars rather than the curved (for access to rear of a 4dr car).

Cheers,

Jamie.

 

[jamie3885]

If ya want ya can take the one out of my track car and get one made up. Would cost ya half the price. Yad take it out in 20 min.

 

[JAMIE-TYPERV6]

Thanks for the offer Jamie. But I've no-one local to me who'd be able to fabricate one cheaply though. There's a crowd down in Cork who do custom cages but by the time they spec it up and then add the additional braxes to it it could work out expensive. I've found a crowd that sell new 10 point OMP bolt in/weld in cages for around 550... pricier than I wanted to go considering I'll still need to tweak it afterwards... but a possibility if I can get the funds together.

 

[JAMIE-TYPERV6]

Bump!!

 

[jamie3885]

Dont weld it in what ever you do. What are they worth ill get a price down down here for ya

 

[JAMIE-TYPERV6]

It's a bolt in Jamie... but needs plates welded into the floor for the mounting points.

Who can you get a price off for one...??

 

[jamie3885]

the ones I have seen have no plates welded in at all. gimme a ring ill take out my one and get a few lads to price it down here for ya

 

[retrolongie]

Demon tweeks are very reasnoble for cages. I have a 4 door bolt in that i might sell if your interested

 

[JAMIE-TYPERV6]

Had a look at Demon Tweeks... Not bad alright. Have you any pictures of the 4 dr cage Aidan?

 

[retrolongie]

Here you go

 

[JAMIE-TYPERV6]

Thanks Aidan.. PM'd.