P popsy b4 Sunday Drivers Apr 12, 2012 #2 I will have one this weekend unsure of make need to take it off and clean it up couldnt get up on ramp today so will be over weekend, its quiet enough but still sounds nice
I will have one this weekend unsure of make need to take it off and clean it up couldnt get up on ramp today so will be over weekend, its quiet enough but still sounds nice
scoobycolm . ISDC Club Member Apr 12, 2012 #3 Think sweepstakes ,Robbie Has one real nice brand new job
R Rob Spec C Octane Boostaholics Apr 12, 2012 #4 Is it to fit onto a sandard centre section? Have a brand new H&S 4.5" if you're interested but I don't think it will ft a standard centre section.
Is it to fit onto a sandard centre section? Have a brand new H&S 4.5" if you're interested but I don't think it will ft a standard centre section.
OP OP D dave b Petrolheads Apr 12, 2012 #5 Robbie I think it's standard but I will check tomorrow, pm me details cheers
G goosie208 Petrolheads Apr 12, 2012 #6 it can be done, a bit of cutting and shutting with a welder and it'll go, though most exhaust places would turn you away i bet if you buy robbies then you'll have an excuse to buy a H&S centre!! to make it fit
it can be done, a bit of cutting and shutting with a welder and it'll go, though most exhaust places would turn you away i bet if you buy robbies then you'll have an excuse to buy a H&S centre!! to make it fit
R Rob Spec C Octane Boostaholics Apr 12, 2012 #8 pm'd you there Dave, all the details inc fitting options. Gimme a call if you're interested