Spoiler bolts

keith dublin

Member Number 161Full ISDC Members 2015
Been getting a rust water mark coming from the rear spoiler water drain holes ..turns out the slide bolts in the spoiles are rusted so need replacing...has anyone done this im looking for all the bolts and the spong sticking pads that go on as well...
Anyone know where they can be got ...or links to new parts
Cheers k
 
I have had mine off and got boot lid redone on the wing I stripped off all the old sponge and when put it back on i used 3 mm window gasket the sponge wares out and wing starts vibrating hence damaging boot lid aswell get the rubber discs that go on wing to stop water leaking into boot as I do get a small drip sometimes hopefully this helps
 
Cherrs lads what are the discs gary where do the go

They where on the underside of wing to seal to boot lid when tightened down to stop water leaking through holes I would say the rusty water mark would nearly buff out on a lot of it
 
A fallout remover/IronX and decent clay bar will remove the rust marks from the paint work Keith. No need to be too abrasive.
 
Back
Top