MARTINGTI
Octane Boostaholics
Im far from a professional but im just going to outline what I done with my new 4 pots before fitting them.
Firstly they were galvanise dipped when they arrived.
I taped off the piston areas so as to avoid getting any spray on the seals etc.
Then I gave them a good coat of ETCH primer.
After that I gave them two coats of Halfords radiant red spray.
I then coated them with a nice coat of Halfords lacquer.
After that I had already gotten SUBARU decals from e bay so I applied them and then gave a final coat of lacquer over them to make sure they stay put!.
And that was that. I really like them and hopefully they will look good and greatly improve my stopping power!!
Firstly they were galvanise dipped when they arrived.
I taped off the piston areas so as to avoid getting any spray on the seals etc.
Then I gave them a good coat of ETCH primer.
After that I gave them two coats of Halfords radiant red spray.
I then coated them with a nice coat of Halfords lacquer.
After that I had already gotten SUBARU decals from e bay so I applied them and then gave a final coat of lacquer over them to make sure they stay put!.
And that was that. I really like them and hopefully they will look good and greatly improve my stopping power!!
Attachments
-
IMG_4874.JPG677.5 KB · Views: 34
-
IMG_4875.JPG598.8 KB · Views: 28
-
IMG_4876.JPG544.4 KB · Views: 27
-
IMG_4878.JPG701.1 KB · Views: 28
-
IMG_4884.JPG602.6 KB · Views: 39
-
IMG_4879.JPG558 KB · Views: 29
-
IMG_4874.JPG677.5 KB · Views: 28
-
IMG_4875.JPG598.8 KB · Views: 27
-
IMG_4876.JPG544.4 KB · Views: 28
-
IMG_4878.JPG701.1 KB · Views: 28
-
IMG_4884.JPG602.6 KB · Views: 38
-
IMG_4879.JPG558 KB · Views: 29