Track day car

e482b37d50cb8e21850bfbc4ef52a2cb.jpg


In the process of making this lower strut brace at the moment,this with the new polypenco bushings should firm up the front end[emoji106]


Sent from my iPhone using Tapatalk
 
Savage stopping power alright horrid on a daily though

Good choice say they will slow the little saxo like you've thrown a anchor out the back ☺

Sent from my SM-G900F using Tapatalk
 
Savage stopping power alright horrid on a daily though

Good choice say they will slow the little saxo like you've thrown a anchor out the back [emoji5]

Sent from my SM-G900F using Tapatalk

That's the plan Ciaran,the cost of going faster is a lot more than than the cost of going fast for longer so until I find lots of money to go faster,this will do[emoji106][emoji1]


Sent from my iPhone using Tapatalk
 
Little progress update with the trailer.
I was going to fully cover the trailer but for now I got a sheet of 8x4 marine ply and ripped it into 4 300mm lengths so this gave me plenty for the two rails.
Then I got a sheet of 2mm aluminium checkered plating to cover the ply this will add strength and look nice[emoji106]
At the moment it's all just sitting in place and will need a few coats too treat the wood before fixing in place
I'd say the trailer is costing a little more than I thought but I can't see it going over 800/900 euro.
There is so much work involved I don't know how it would pay you to do it but that said its been an experience for me and I'm enjoying it.
So work left too do:

1. Make the ramps
2. Mudguards
3. Finish paint
4. Dolly wheel
5. Lights
6. Handbrake
7. Safety strap

Latest photos from today:

30d06245975fbcbea61b2511a46934f7.jpg


37e713e3976c27e219f95bc69ec6809d.jpg


a6c0c04eda6efbcbe8da2e005fd52246.jpg


0c6e44f8fb131cd85432d236aa8f1bc1.jpg






Sent from my iPhone using Tapatalk
 
Just about to fit some gauges
It would never pass or go back near standard I'd have to start from scratch
 
Ah rite I didn't see the regs on it,they must be keeping the class tight.


Sent from my iPhone using Tapatalk
 
Some more work done today on by bushings it's all ready no for fitting so just hope it all fits back together ok[emoji27]

Cutting 2 50mm pieces
d224ced8f69f3888ee60062e6c1ac41a.jpg


Cutting them into 50x50x90 blocks
72caf25077e5d222818671563c38a93d.jpg


One of the rear block bushings finished with the front round ones.
28937768f535c2a87cf53162f5b20372.jpg


All marked up for fixing holes
0eb0d3904300337b746ce78a39244866.jpg


Now all parts are ready to refit on the Saxo this should stiffen up the front end a bit[emoji106]
3e2b8bd9c5ffb5a80b6dc5ae2edbe739.jpg





Sent from my iPhone using Tapatalk
 
Last edited:
Back
Top