marksscooby
Petrolheads
what you do first is clean the calipers back to the bare metal to make sure its clean for painting with a drill and steel wool bit or a wire brush. i used the drill with the steel bit.
first clean it down to get ready for painting, the mistake i made here was the caliper was not clean enough so the paint chipped off so i had to clean it properly this time
then i gave it the first coat, using simoniz high temp paint and i used holts white for the subaru logo i done 3 coats in total
this pic is the caliper painted and the subaru logo done i used a kitchen roll holder and cut it and used the rough side and sprayed the white paint on to the holder and pressed against the subaru logo and it done the job fine i used 3 coats on this too
rear
first clean it down to get ready for painting, the mistake i made here was the caliper was not clean enough so the paint chipped off so i had to clean it properly this time
then i gave it the first coat, using simoniz high temp paint and i used holts white for the subaru logo i done 3 coats in total
this pic is the caliper painted and the subaru logo done i used a kitchen roll holder and cut it and used the rough side and sprayed the white paint on to the holder and pressed against the subaru logo and it done the job fine i used 3 coats on this too
rear