C ckay Petrolheads Sep 29, 2008 #1 How Lad's , I can't seem to get the glass cover off the spot as I need to change the bulb. Is there a trick I need to know about ? cheers lads.
How Lad's , I can't seem to get the glass cover off the spot as I need to change the bulb. Is there a trick I need to know about ? cheers lads.
Altezza-Dan Octane Boostaholics Sep 29, 2008 #2 remove the bulb from the back of the light? ie enter from behind the wheel arch lining?
P pete Petrolheads Sep 29, 2008 #3 remove the light from the bumper and then take the bulb out from the back
B briancollins Octane Boostaholics Sep 29, 2008 #4 what pete said. Tired bolts and light out. Be careful, the adjuster looks like a bolt, its smaller though so dont touch that, 3 ten mil bolts.
what pete said. Tired bolts and light out. Be careful, the adjuster looks like a bolt, its smaller though so dont touch that, 3 ten mil bolts.
OP OP C ckay Petrolheads Sep 29, 2008 #5 Thanks lads, But I can't get the light off the bumper .. do I just use a normal screw driver? although I tried this and couldn't budge any bolts.
Thanks lads, But I can't get the light off the bumper .. do I just use a normal screw driver? although I tried this and couldn't budge any bolts.
M markobucko Octane Boostaholics Sep 30, 2008 #7 are they not philips head screws???? should be a h3 bulb with the attached wire....
B briancollins Octane Boostaholics Sep 30, 2008 #8 U can use a screw driver but they have a bolt shape around them, 10mm, a screw driver is completely useless as they do be tight. Rachet and socket is the only job.
U can use a screw driver but they have a bolt shape around them, 10mm, a screw driver is completely useless as they do be tight. Rachet and socket is the only job.