Any ideas?

Hey lads started car this evening after work and found it wasnt stable at idle at all so after it warmed up i took for a spin and i could barely get it up to 3000rpm in any gear
it wasnt boosting at all so i pulled in and let it tick over it sounded like it was going to cut out ,its a version 4 sti i replaced the maf sensor over a year back put still have a apexi induction kit on it could it be sensor again?any ideas

Hey Javy4,
Sounds like your car is in safe mode (won't go over 3000 rpm),
It dose seem like some sensor is gone :dunno: best get a diagnostic check
at your nearest Subaru dealer to find out .

Niall.

Maf id say, do as that cork fella said

MAF again I'd say - induction kits are renowned for damaging them.....

I'd replace the MAF and then reset the ECU

Alan.

Yep sounds like MAF...

Hey lads thanks for the feedback,turned out water was getting in from the cf bonnet and runing straight down on the filter playing with the maf sensor ,so i took out cleaned it up and dryied it out completely,
sorted out bonnet and stuck a heatshield over the induction kit .got it checked on computer and sensor seems to be fine lucky enough.