Exhaust question

J

joey

Petrolheads
I got an exhaust systen today.Its a 3" system but the flange where it joins the down pipe it's 2.5" .
My down pipe is 3" so can't see it joining up. Is there a spacer/adopter you can buy to make it fit?
 
Grim speed do a adapter I bought one last year
Somewhere around 80 euro iirc
I'd sell it for 50
Did about 1k miles on it



Sent from my iPhone using Tapatalk
 
[quote author=SCOOBYCOLM link=topic=44527.msg514467#msg514467 date=1429808588]
Grim speed do a adapter I bought one last year
Somewhere around 80 euro iirc
I'd sell it for 50
Did about 1k miles on it


Sent from my iPhone using Tapatalk
[/quote]
Don't think that will do me as there is a lip for using the oem gasket on that adopter and i have no place on the exhaust flange for that type gasket.
 
Think I used the donut gasket alright when I fitted it
Alright
Souhans or similar so be your best bet [emoji106]


Sent from my iPhone using Tapatalk
 
Was the flange on the cat back flat or was it like oem and had a place for the gasket to fit into?
 
[quote author=WAGON DEC... link=topic=44527.msg514464#msg514464 date=1429804297]
Ring souhan exhausts they could weld on a 3" to yours

wagon dec


[/quote]
Ya I have a 3" flange in the garage so might just weld it on. Thanks
 
I think the donut gasket was in the original downpipe and it actually sat in to the adapter in between both at least 75% of it
Don't think it went in mid section at all as didn't fit in iirc
 
Thanks but I'm in cork. I was looking at them online earlier so say it's the same as you have.i think the ones I was looking at are designed for using a 3" down pipe with the oem cat back system.
 
You must log in or register to reply here.
Back
Top