Boost gague (no power)

S

scooby.grrr

Sunday Drivers
Help needed, can anyone advise me on what to do with my boost gague I have checked everything and it seems ok. What should I do to get it back working here is some Picts

aacea2ed.jpg


28f471ae.jpg


50278de9.jpg
 
:icon_omg: that sender looks worse for wear! id say your problem lies in the wiring there

take all the tape off the blue and yellow wires and assess the wiring!
 
The sender looks ok and the wires are ok there is no power at the connection where I plug in the sender so my problem is inside the car. Has anyone got a wire diagram ? And I will look in behind the dash.
 
Here is my problem can anyone tell me where the wires go ? I have a live and earth coming from the light switch can I use them ? I connected up the red and black and the gauge worked it went down from 0 to 25 I take it's because it was not wired up correct any help would be great.

02cf0dee.jpg
 
impossilbe to tell you what wires go where, but you will most likely have a 12v ignition, a permanent 12v feed, ground/earth and a wire linked unto the wire

your best bet! rip it all out and start afresh! its clearly wired a bit iffy

i took my 12v ign, perm 12v and ground from behind the stereo
 
I finally have the boost gauge working properly and it's going up to 1.4 is this ok ?
I hear a few have the boost at 1 bar to save further problems with the engine.
 
:thumbsup: Once i feel comfortable with using the avcr i will do that,
and hopefully i will be able to get it mapped next month.
 
setting a or b or off.

if turn it off be actuator pressure at 0.5 bar.

access a and b in settings menu
 
You must log in or register to reply here.
Back
Top