a bit of help required

got my forged engine, fmic and hks induction kit fitted,

i'm doing away with the dump valve (hks ssqv) for the time being so i blanked off on the intercooler pipe where the dump valve goes, but i want to know what to do with the small pipe that was connected from the dump valve to the top of the inlet manifold ? do i blank it off or run it somewhere ?

and i want to know what to do with the small pipe that went from the bottom of the boost solinoid to the small nipple on the bottom of the standard air box that i have replaced with hks ind. kit ?

do i blank this off also or run it somewhere ?

thanks gretts.

anyone got any help for me on these issues?

Hi why are you doin away with the dump valve ? It is needed to stop back pressure in the intake when you come off throttle so if removing the hks one you will have to refit the standard one as for the pipe off the boost solenoid just let it vent to atmosphere

it's temporaly done away with waiting to get the right piece of pipe to fit it,

and vent to atmosphere on the other pipe,

thanks.

Oh right I just wouldn leave it too long man the pipe that would have been on the dump valve you have to block that and the other one to atmosphere