Rocker gasket sealing question

Codders

Codders

Member Number 162Full ISDC Members 2015
Hey Guys

To tighten up the new camshaft pulleys I need to take the left rocker cover off. (to somehow block the cams apparently)
Now the question is, do I need to replace the gasket or just put back the old one? It never leaked but I can see there had been some sealant used before.
Which sealant is recommended to use?

Cheers
Peter
 
shouldnt have to take the cover off to tighten the pulley
is the belt fitted yet???
whats the torque on the pulley bolt??
 
No timing belt yet on marko.
Not sure about the torque yet - Have to look it up.. they were tight like hell when I was takin them off. :ponder2:
 
I've just found something like this on the net.. LOL maybe I should give it a go :lol:

DSCF0172.jpg
 
To block/prevent the camshaft pulley from moving if you want to tighten it with those 80 Nm :|
 
As said above,

If you rely on the belt alone in its normal position, then the belt will slip when your tightening the pullies
 
You must log in or register to reply here.
Back
Top