F
fat-controller
Guest
Hi have a question regarding fitting a boost controller,its a greddy profec b spec one(manaul says its handy,but dont wanna blow my engine) its analog not digital so setup is not a problem.I was told by a mechanic in carroll and roche to fit one as i wont be running it over the standard factory boost,Anyway i just need a few details the motor that goes under the bonnet has a in and out port on either side and a third pipe tees off the inlet manifold and into the controller in the car,just wondering what pipes connect to the IN and OUT ports on the motor and do i have to remove the factory boost controll valve to fit it.any help would be great as im going to get it mapped satuday so i would like to have it connected by then.thanks 
