Need some info on fitting an apexi boost control valve

T

TommyM

Petrolheads
I got an apexi boost control valve for my car ,i just need info on fitting the valve:

my cars setup is the same as in the first pic i have added (3 pipes to standard boost control valve)


the apexi valve only takes 2 pipes ,so i think i should plumb it like the 2nd pic i have added ...... is this correct?
 
u only use 2 pipes one from the actuator and the other from the turbo housing , then blank the other one of going to the air intake :thumbsup:

what are u using to control solenoid ?
 
[quote author=JPtypeRA link=topic=17550.msg214485#msg214485 date=1251460313]
u only use 2 pipes one from the actuator and the other from the turbo housing , then blank the other one of going to the air intake :thumbsup:

what are u using to control solenoid ?
[/quote]



ok thanks ,im using the Apexi control kit .....just wasnt sure about the valve
 
how can the small vacuum pipe be connected to the intake pipe???
one is 8mm at the valve and the intake is probably 10mm or more
:dontknow: :dontknow:
 
Think they factory system uses a step down mark. Its only to bleed off the boost pressure back to the intake system. Not needed on aftermarket boost kits
 
You must log in or register to reply here.
Back
Top